Step 3 – Rotate Mould Into Ready Position PDF  | Print |  E-mail

The mould is placed on a turntable that rotates the mould into the ready position, beneath the concrete feed system and compaction roller heads. From this point on, production of the pipe is fully automatic and is controlled by the production programme.

< Prev   Next >
 

Rotate into Position

Rotate concrete pipe mould into position

Downloadable information

Terms of contract Queensland
(pdf160k )

Terms of contract Victoria
(pdf164k )

Terms of contract WA
(pdf160k ).

Disclaimer

The information held throughout this website has been prepared with all reasonable care and thought, however RCPA and its related companies and agents do not warrant the accuracy of any information shown and do not accept any liability for negligence, any error or discrepancy or otherwise in the items shown.

RCPA Benefits

Our advanced process is approximately 4 times faster than traditional methods, reducing delivery times and delays.

There is very little waste, very little water used and recycling takes care of the rest.

 

 

Contact Us

QLD Ph: (07) 3804 6266

VIC Ph: (03) 9746 0600


W.A. Ph: (08) 9434 4055